Pohled na držák

Sketch of the mount

Držák DP101M E9602 byl navržený k tomu, aby umístil moderní LCD nebo plazmu monitor/TV na zeď. Jeho nostnost je 60 kg. Držák dovoluje snadnou úpravu náklonu (bez nářadí) 15°.

The DP103M version is fixed by flat bar, whereas the DP101M - with two screws with hex Allen head.

The wall has to carry the load of the panel and the mount, including a wide margin of safety.

The mount cannot be installed on walls that do not provide firm hold (steel stud, old cinder block, plaster panel etc). If you are uncertain about the nature of the wall, consult an installation company.
The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.
The basic required tools (not included): 3/16" drill bit, 1/2" masonry bit for brick / concrete block installations, electric drill, wrench or socket set, Phillips screwdriver.

Safety warning.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer. Improper installation may cause damage or serious injury.
Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Some operations should be performed by two skilled people!

Improper installation may cause damage or serious injury.
Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.

Name	Flat panel wall mount DP101M (tilt)
Code	E9602
Screen size range	30” – 50”
Distance from wall	80 mm
FDMI / MIS	VESA
Load capacity	60 kg
Tilt adjustment	+/- 15°
Rotation angle	-
Dimensions	765x530x80 mm
Weight	6.4 kg

Kód	E9601	E9602	E9603
Název	DP101S	DP101M	DP101B
Rozměr TV v palcích	23-37”	30-50”	32-60”