MŮJ KOŠÍK
Můj košík je prázdný

Zboží stažené z prodeje

IR Remote Control Extender POWER-LINK (using existing ant. install.)
Kód zboží: R93109
Zboží je stáhnuto z nabídky
IR Remote Control Extender POWER-LINK (using existing ant. install.)
View of the device (re-emitter and receiver).

IR Remote Control Extender POWER-LINK (using existing ant. install.)
View of the device.

The equipment consists of IR receiver that converts the control IR commands to 11 MHz HF signal and lets it into antenna installation, and IR sender ("reemitter"), which changes back the signal to its IR original form. There are also available additional IR receivers alone.

In order to properly position the IR emitter it is needed to connect both modules and choose the place for the sender (A) experimentally (Fig. 1).


The IR controllers of the equipment that is to be commanded should be put into a box , making impossible direct operation (the equipment does not "see" the controllers - it ought to be tested for sure). The sensor of the receiver (B) has to be put into the box, too. Then the IR reemitter ought to be linked with antenna installation. The same is made with IR receiver. It should be connected to an antenna outlet, and the cable leading signal to TV set - to the IR receiver's socket. (Fig. 2).
a - Make sure that sender (emitter) A and sensor (receiver) B are properly placed and fixed, and direct IR transmission is always possible.


In the case of bigger installations or high attenuation taps being used it may be needed to adjust the HF output signal, which can delicately be made with a small size screwdriver.
Notice: This extender is not compatible with Cyfra+ receivers.
Zboží je stáhnuto z nabídky
 
IR Remote Control Extender POWER-LINK (using existing ant. install.)
Kód zboží: R93109