MŮJ KOŠÍK
Můj košík je prázdný

TV, TV-SAT

Schémata

Pass-through multiswitch system for one satellite
in apartment building
APPLICATION OF 5-INPUT MULTISWITCHES OF MS-5xx SERIES
Here's an example of installation diagram in apartment building. The system provides to each outlet all available terrestrial broadcasts and satellite programs from one satellite (chosen at the stage of initial planning, usually by the administrator of the building). The antennas and triplexer are mounted on the roof, the set of channel amplifiers and splitters - in the attic. The system is expandable and allows to implement new functions in the future, e.g. CCTV monitoring, similarly to this diagram. During construction or renovation of the building it is very important to run the appropriate cables to all points where one may need antenna outlets. It is worth to use quality satellite coax, in order not having to exchange the cable after several years. The system has to be designed and installed by professional installation company.
Pass-through systems based on radial multiswitches with passive terrestrial paths are less flexible than tap networks, so they are dedicated for networks with dozen or so outlets. The undoubted advantage of this type of installations, however, is the ease of their construction (single riser).
Satelitní parobola 110cm FAMAVAL 110 LHAnodiovaná FM Anténa Dipol 1RUZ PM A (všesměrovál H+V)Dipol 19/21-60 DIGITAL - 19-element UHF TV AnténaAnténní slučovač ZA-104Ms (FM/6-12/21-69/75)Koaxiální kabel 75Ohm TRISET-113 1,13/4,8/6,8 [1m]5 kanálový SAT/TV rozbočovač SS-504 TerraTV/R/SAT zásuvka koncováMS-553 cascade multiswitch Terra (5-input, 4-output)MS-553 cascade multiswitch Terra (5-input, 4-output)MS-553 cascade multiswitch Terra (5-input, 4-output)Multiswitch Terra MS-554 (5 vstupů, 4 výstupy)Anténa rádiová DIPOL-4/DABLNB konvertor QUATRO INVERTO 0.4dB
Pass-through system for one satellite, 8-40 outlets

SatNet program allows to design a practical implementation of the system.
To select the right components, the data for the design must contain:
  • network topology,
  • levels of satellite signals,
  • levels of terrestrial signals,
  • attenuation of the cable/s.
Each element of the installation has its control points (connections with the rest of the network, including the cable runs) . Clicking on them, the user of the program can see detailed characteristics (signal levels for different frequencies). If the signals meet the adopted criteria, they are colored in green, if some levels are too low - in blue, if too high - in red. In the diagram below all the points are in green - the project is consistent with the assumptions.
Screenshot from SatNet utility
The design made with the SatNet program can be saved to a file. The file saved for the case shown above can be downloaded here. So anyone can install the SatNet program and load this file to test the utility and modify on their own (e.g. extend) the original example.