View of the multiplexer . AC/DC power converter in not included in the set and should be purchased separately

Rear view

View of the packaging

Video multiplexer RV-8/16KR enables to distribute signals from eight inputs to sixteen outputs according to configuration set by the user. The RV-8/16KR has the default array set as eight independent video diplexers 1/2 (Fig. 1). It is easy to re-program the array using jumpers located on the front panel. There are 22 combinations available. The example four ones are given in the figures. When programming, the table of possible combinations should be employed. The vertical jumpers activate respective inputs and the horizontal ones - connect respective outputs. The input 1 has no assigned jumper as it is always active.

The multiplexer is designed for continuous indoor operation. The RV-8/16KR works with any CCTV cameras. The LED informs about power on. Multiplexers can be connected in series..

Example: There is a need for 4 video multiplexers 1/4 (one input, four outputs).

On the left side of the table one can find the line containing required devices: 4 x 1/4 (position LP5)The fields with "1/4" forks show inputs (the upper part of the table) and assigned to them outputs (the lower part of the table). The fields with arrows show which outputs are consigned to the same input seen on the left. In the right part of the table the columns are assigned to the respective jumpers. In the same line there is given information about which jumpers have to be put (+), and which are unused (-). The example is shown in Fig. 2. Specification

• Number of inputs: 8 BNC
• Number of outputs: 16 BNC
• Bandwidth: 0-90Mhz (-3dB)
• Input impedance: 75ohm
• Output impedance: 75ohm
• Supply voltage: 12VDC
• Current consumption: 150mA
• Gain: 0dB
• Dimensions:195x36x225mm
• Weight: 520g

Fig.1. The array of 8 x 1/2 video diplexers

Fig.2.. The array of 4 x 1/4 video multiplexers

Fig.2.. The array of 4 x 1/4 video multiplexers